Main Navigation

MSDS Sheets

MATERIAL SAFETY DATA SHEET

 Last Update 08 JAN 2013

 1.  PRODUCT IDENTIFICATION

 R400 RUBBER COATING

     MANUFACTURER

All White Manufacturing, Inc.
1507 SW 21st Avenue
Fort Lauderdale, Fl 33312

 P# 954-583-9178

 

2. COMPOSITION / INFORMATION ON INGREDIENTS

Ingredient                                       Case Reg. No.      OSHA PEL       %wt.
Acrylic Polymer                   Not Required       Non-Haz.           86%
Tio2                                        13463-67-7           Non-Haz.           14%
Kathone LX 1.5%                Not Required      Non-Haz.         >.01%
Non-Mercurial Fungicide   Not Required      Non-Haz.         >.01%

3. PHYSICAL / CHEMICAL CHARACTERISTICS

Boiling Point                                           100 C / 212 F
Specific Gravity H2O-1                          1-1.2
Vapor Pressure (mm Hg )                     17mm Hg at 20 C
Melting Point                                           0 C / 32 F
Vapor Density (air - 1 )                           >1
Evaporation Rate ( Butyl Acetate - 1 )  >1  
Appearance and Odor                           White viscous liquid

      4. FIRE AND EXPLOSION HAZARD DATA

Flash Point                                              Non Cumbustible
Auto Ignition Temperature                  Not Applicable
Lower Explosive Limit                         Not Applicable
Upper Explosive Limit                          Not Applicable

          UNUSUAL HAZARDS       
      Material May spatter if temperature exceeds 100C/212F.

       
   EXTINGUISHING AGENTS 
      Use extinguishing media appropriate for surrounding fire.
 
    PERSONAL PROTECTIVE EQUIPMENT
      Wear self-contained breathing apparatus and full protective gear.

5.  STABILITY AND REACTIVITY

         Instability: This material is considered stable.

         Hazardous Polymerization: Will not occur

         Incompatibility:  There are no know materials which are incompatible with this product

6.  HEALTH HAZARD DATA


         Primary Routes of Exposure: Inhalation

        Inhalation: Inhalation of vapor or mist can cause headache - nausea


       Emergency and First Aid Procedures


       Eye or skin flush with water

      Ingestion - give two (2) glasses of water to drink and call physician


7.  PRECAUTIONS FOR SAFE HANDLING AND USE


      Steps tp be taken in case material is released or spilled

      Dike spill, transfer to EPA approved metal container for recovery and disposal.


      Waste Disposal Method

     
      Decant to landfill.  Incineration is possible but not likely due to the high water content.

   
     Precautions to Be Taken in Handling and Storage

     Keep from freezing do not store above 140F


8.  CONTROL MEASURES

Respiratory Protection:    None required if good ventilation maintained

      Ventilation-local exhaust: Mechanical at point of containment

Protective Gloves: Impervious

Eye Protection: Safety glasses

                                               Work Hygiene Practices: Standard care to avoid splattering


Terms and Conditions   Help   Site Map
Content copyright . All White Manufacturing Inc. All rights reserved.
Website Builder